Electrifly REFLECTION Bedienerhandbuch Seite 14
- Seite / 24
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
❏ 5. Glue the aileron servo into a wing servo mount and
glue the assembly into the bottom of the bottom wing with
the output shaft toward the rear.
❏ 6. Cut a small hole in the fuselage to allow the elevator
servo wire to pass through to the left side of the fuselage.
pass the rudder servo wire down through the hole that the
rear wing struts pass through. Connect the servos to the
receiver and mount the receiver to the fuselage with double-
sided foam tape. Power up the radio system and center all
three servos.
❏ 7. Insert two Z-bend clevises (A1) into a double-sided
servo arm that fits your servo. Install the servo arm on the
aileron servo in the position shown.
❏ 8. Install a Z-bend clevis (A1) into a single-sided servo arm
that fits your elevator servo. Install the arm onto the elevator
servo so that it is straight down with the servo centered.
❏ 9. Install a Z-bend clevis (A1) into a single-sided servo arm
that fits your rudder servo. Install the arm onto the elevator
servo so that it is straight up with the servo centered.
❏ 10. Using an Easy-Touch bar sander with 220-grit
sandpaper, sharpen the ends of all the 1mm [3/64"] carbon
pushrods. This will make them much easier to install
through the Z-bend clevises.
❏ 11. Slide two 1 x 90mm [3/64" x 3-1/2"] aileron pushrods
through the clevises in the aileron horns and servo arms.
Adjust the clevises until the ailerons are centered with the
servo centered. When you have the alignment correct,
secure the pushrods with a drop of glue where the pushrod
enters the clevis. Keep glue away from the end of the clevis
where it pivots in the arm or horn.
14
- INSTRUCTION MANUAL 1
- & OTHERS...FOLLOW THESE 2
- IMPORTANT SAFETY PRECAUTIONS 2
- INTRODUCTION 2
- TABLE OF CONTENTS 2
- PROTECT YOUR MODEL,YOURSELF 2
- DECISIONS YOU MUST MAKE 3
- ADDITIONAL ITEMS REQUIRED 4
- KIT INSPECTION 5
- KIT CONTENTS 5
- ORDERING REPLACEMENT PARTS 6
- BUILD THE AIRPLANE 7
- Assemble the Fuselage 9
- Assemble the Wing 10
- Final Assembly 12
- Radio Setup 13
- Mount the Motor & Gearbox 15
- Firewall-Mounted Motor System 17
- GET THE MODEL READY TO FLY 18
- PREFLIGHT 19
- CHECK LIST 20
- AMA SAFETY CODE (excerpts) 20
- MOTOR SAFETY PRECAUTIONS 20
- OTHER ITEMS AVAILABLE FROM 21
- GREAT PLANES 21
- ANGLE TEMPLATES 23
Philips 8718696483763 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Lichtpunkte Philips 8718696483763.
Wir stellen 1 PDF-Handbücher Philips 8718696483763 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Datenblatt
Kommentare zu diesen Handbüchern