Electrifly REFLECTION Bedienerhandbuch PDF herunterladen (Seite 14)

❏ 6. Cut a 45° beveled edge on the sides and tips of the

fuselage braces with a sharp hobby knife. Make a shallow

cut along the line shown in the picture. Do not cut all the way

through the foam for this cut.

❏ 7. Align the colored pattern on the fuselage braces with the

colors on the fuselage and glue them into position. These

braces mount at a 45° angle to the fuselage, matching the

bevel cuts you made in the prior step.Bend the triangle shaped

tips of the braces inward to glue against the fuselage.

❏ 1.Glue the inner wheel pants to the outer wheel pants.

Be sure to make one left and one right wheel pant.

❏ 2. Assemble the axle supports (D1), axles, wheels, and

wheel collars (D6) to make two landing gear assemblies.

Secure the wheel collar to the axle with a drop of glue, but

do not glue the axle to the axle support until later. Be sure

that the wheels rotate freely.

❏ 3. Glue the wheel pants to the wheel collars.You do not

need to align the position of the axle supports at this time.

❏ 4. Slide the wheel assemblies onto the 2 x 190 mm [5/64"

x 7-1/2"] landing gear rods. Rotate the assemblies so that the

wheel pant bottoms are parallel with the wings and the wheels

are pointed straight ahead. When satisfied with their fit, apply

a few drops of glue to the axle supports at the axles and at the

landing gear rods.

Assemble the Landing Gear

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Electrifly REFLECTION Bedienerhandbuch Seite 14